Modified on Wed, 14 Jan at 12:38 PM

MOD Wedge Bag | User Guide

In this article: You’ll learn how to install and secure the MOD Wedge Bag under your saddle.

This Article Applies to the Following Bikes

Difficulty

★☆☆ Easy

Estimated Time

0 - 5 Min

Before You Start

Tools you will need

• 3mm Allen Wrench included in your MOD Wedge Bag

Preparation

• Ensure your bike is off and standing securely on its kickstand

Steps | All Bikes

Step 1: Attach the Mount Bracket

1. Loosen the two Allen bolts on each side of the mount to widen the bracket enough to fit over the saddle rails.

2. Hook the bracket onto the two saddle rails.

3. Tighten both Allen bolts evenly until the mount is fully secure and does not move.

Step 2: Attach the Bag Onto the Mount

• Slide the wedge bag forward onto the mount until you hear or feel a click.
• Undo the Velcro strap at the front of the bag, wrap it around the seat post, and tighten firmly to keep the bag stable.

To Detach the Bag from the Mount

• Undo the Velcro strap at the front of the bag and unwrap it from the seat post.
• Press the release tab and pull the bag backward to detach it from the mount.

Troubleshooting

• Bag feels loose or shifts while riding → Make sure the Velcro strap around the seat post is tight and both mount bolts are fully secured.
• Bag will not slide onto the mount → Check that the mount is properly aligned under the saddle rails and that nothing is blocking the slide track.
• Bag does not click into place → Slide the bag fully forward until it stops. Gently pull back to confirm it is locked.
• Mount moves after installation → Loosen the bolts, reposition the mount evenly on both saddle rails, then retighten both bolts firmly.

FAQs

• Do I need tools to install the bag?
  Yes. A 3mm Allen wrench is required to secure the mount to the saddle rails.
• Can I remove the bag without removing the mount?
  Yes. The bag slides off using the release tab while the mount stays attached to the saddle.
• Will this fit any saddle?
  The mount is designed to fit most standard saddle rails. Saddles with non-standard rail shapes may not be compatible.
• Can I ride without the Velcro strap attached?
  No. The Velcro strap helps stabilize the bag and should always be secured before riding.

Warning

⚠️ Important Safety & Liability Notice

These instructions are provided as a general installation guide. Always make sure the mount bracket bolts and the Velcro strap around the seat post are properly tightened and secure before riding.

Failure to properly install or secure the bag may cause it to shift, detach, or interfere with riding, which could result in damage to the bike, loss of personal items, or injury.

Periodically inspect the mount and strap for tightness, especially after the first few rides or when riding on rough roads. If you are unsure about installation or notice any movement, stop riding and adjust the bag before continuing.

MOD BIKES is not responsible for damage, injury, or loss caused by improper installation, use, or failure to follow these instructions.