Modified on Mon, 19 Jan at 2:56 PM

Two Fish Quick Cage Bottle Holder | User Guide

In this article: You’ll learn how to quickly install the Two Fish Quick Cage Bottle Holder using the built-in strap.

This Article Applies to the Following Bikes

Difficulty

★☆☆ Easy

Estimated Time

0 - 5 Min

Before You Start

Preparation

• Ensure your bike is off and standing securely on its kickstand.
• Decide where on the bike you want to mount the bottle holder.

Steps | All Bikes

Step 1: Open the Strap

• Undo the Velcro strap on the bottle holder so it opens fully.

Step 2: Position the Holder

Place the bottle holder against the bike frame.

• Common mounting points are the down tube or seat tube

• This is especially convenient on MOD City and step-thru frames

Step 3: Wrap and Secure

• Wrap the strap tightly around the frame and press the Velcro firmly to secure the holder.

Troubleshooting

• Bottle holder feels loose → Re-tighten the strap and make sure it is wrapped flat against the frame.
• Bottle rubs against cables or frame → Reposition the holder slightly higher or lower on the frame.

FAQs

• Do I need tools to install this?
  No. The bottle holder is installed using a Velcro strap only.
• Can I move it to a different spot later?
  Yes. Simply undo the strap and reposition it anywhere on the frame.
• Will it fit larger bottles or tumblers?
  Yes. The holder is designed to accommodate standard bottles and larger insulated drink containers.

Warning

⚠️ Important Safety & Liability Notice

Always make sure the bottle holder is securely fastened before riding. A loose holder may shift during riding and interfere with steering or braking. Periodically check the strap for tightness, especially after the first ride.

MOD BIKES is not responsible for damage, injury, or loss caused by improper installation, adjustment, or use of this accessory. Local laws and regulations may apply.